Autel Support Communities
Autel Support Communities
Welcome, Guest     Sign in
Communities > TPMS > TS401 > 2017 Chevrolet Cruz
2017 Chevrolet Cruz

461 Views 2 Replies Latest reply: 2017-04-17 19:12:00


  •   Level 1   
    (8) points
    teroma25
    2017-04-15 18:26:30
     My TS401 won't relearn the sensors. It just says "no sensor found". Is it because it's a 2017 or ??? There is no setting for 2017 only as high as 2016 when trying to set vehicle. I tried a different chev vehicle setting but it didn't work. It's always worked fine for every other vehicle but not this 2017 Cruz. 

  •   Level 2   
    (15) points
    Over Worked Tech

    2017-04-16 06:34:05 (Reply to:teroma25)

     You may have to wait for an update. I think they switched some to 433mhz sensors in 2017. Most of the older ones had 315mhz.

    Was the vehicle in relearn mode or were you just trying to read the sensors? I would have assumed it would have triggered the sensor even if it couldn't read it. The frequency to trigger the sensors should be the same so the car should have seen the sensor even if the tool didn't, I would think anyway.

    You can possibly try and look up an older Chevrolet Malibu, I think some of those had 433mhz sensors. See if you can find one with a listing for 433mhz and try that. Don't know if it will work but its worth a shot.

  •   Level 1   
    (8) points
    teroma25
    2017-04-17 19:12:00
     Yes I think I'll have to wait. I figured out after the car was gone that they changed to 433 for 2017. It was in relearn and didn't trigger at all. 
1
  Total1 Pages